Right Of Complaint - RUSTA 907511930101 Gebrauchsanweisung

Front protector Screw for fan blades
Fan blades
Screw
USE
• Check that the voltage in the electrical outlet is the same as specified on the floor
fan's nameplate.
• Press down on the desired mode for speed setting: 0 (off), 1 (slow), 2 (medium) or 3 (fast).
• Set the desired angle, tighten the nuts. Use the included wing nuts to help tighten the
nuts when setting the angle.
• Set the desired height.
CLEANING
• Remove the plug from the electrical outlet. Carefully remove the front and back protection
from the fan blades. Wipe off the oil residue with a soft cloth and mild cleaning agent.
• Polish with a dry cloth. Never use polishes or agent which could damage the surface of
the floor fan. Mount the fan blades and carefully screw on the front and rear protectors.

RIGHT OF COMPLAINT

By law the product must be returned to the place of purchase along with the original
receipt in the event of a complaint. The user is liable for any damage to the product that
is caused by not using the product for its intended purpose or by not following this user
manual correctly. The right of complaint will not apply in these instances.
INFORMATION ABOUT HAZARDOUS WASTE
Used products should be handled separately from
household waste. They should be taken for recycling in
accordance with local rules for waste management.
Rear protector
Motor
Lock nut
Control panel
Washer
Power switch
Washer
Nut
Screw
Cord holder
Cable terminal
Particle
Pipe base
Spiral protector
Power cord
3