IBIZA LIGHT JDL032LED Bedienungsanleitung

Instructions of Use
1. Carefully put this product onto a clean, flat, and solid surface, such as
a table top or cabinet-top, and connect to power.
2. Set the ON/OFF switch to ON position. All the LEDs of the unit will be
start working. Use the SPEED potentiometer knob to adjust the blinking
speed of the LEDs. Turning the knob clockwise can increase the speed,
while turning the knob counter clockwise can decrease the speed.
3. To use the unit for sound-controlled blinking. Please adjust the
SPEED knob to the slowest position. Then you can use the MUSIC
potentiometer knob to control the LEDs to blink to the volume of the
music.
4. To change colour effect, please pull out all the plugs in the row jacks
and detach the combination tube for a new combination, as shown in the
right figure.
5. Use source: DC 12V---500mA.
6. Please use a wet, soft cloth instead of sharp tools for cleaning.
CAUTION
Please read through this manual before use.
Please keep this unit out of reach of little children or pets.
Disconnect this product from power immediately in case of malfunction.
Do not resume use until it's repaired.
Please unplug the power cord if you want to stop use of this unit for long
time.
Electric products must not be put into household waste. Please bring them to a recycling
centre. Ask your local authorities or your dealer about the way to proceed.
L E D P A R T Y L I
L E D P A R T Y L I
( J D L 0 3 2 L E
( J D L 0 3 2 L E
L E D P A R T Y L I
L E D P A R T Y L I
( J D L 0 3 4 L E
( J D L 0 3 4 L E
INSTRUCTIONS
ENGLISH
WWW.ibizalight.com
G H T 3
G H T 3
D )
D )
G H T 6
G H T 6
D )
D )