EMKO ESM-3712-HCN Bedienungshandbuch Seite 11

Buzzer Function Selection Parameter
Buzzer is inactive.
Buzzer is active if an alarm occurs.
Buzzer is active during sensor failures.
Buzzer is active during alarm or sensor failures.
Buzzer is active during this time
If buzzer function selection parameter value
observed. Buzzer stays active during this time. It can be adjusted from 1 to 99 minutes
When this parameter is 1, if decrement button is pressed,
condition buzzer is active till buzzer silence button is pressed.
Communication Mode Selection Parameter
Slave ID Parameter
Device communication address parameter (1 to 247).
Programming Section Accessing Password
It is used for accessing to the programming section. It can be adjusted from 0 to 9999. If it is
selected 0, password will not be asked
i
,
is selected "Cooling". If operation type is selected "Heating " ,skip to the
6.3 Modbus Adresses of Device Status Parameters (Read Input Register)
MODBUS ADRES:30001
MODBUS ADRES:30002
MODBUS ADRES:30003
A
MODBUS ADRES:30004
MODBUS ADRES:30005
6.4 Operation Graphics of Alarm Output and Alarm Types
Power
°C
Alarm
Status
Alarm
Output
Active
Led
Alarm
Output
PROKEY communication selected.
RS 485 communication selected.
( Default = 1 ) MODBUS ADDRESS=400
, , ,
Temperature Value
Led Status : 0.bit C Led,6.bit Compressor Led,
7.bit Alarm Led, 13.bit Program Led,
14.bit Set Led
Device Status : 0.bit Alarm Status
2.bit Buzzer Status
3.bit Sensor Break Status
Output Status 0.Bit Compressor Output,1.bit Alarm Output
Device Type and Device Version
Time
Time
Time
Time
( Default = 0 ) MODBUS ADDRESS:40023
( Default = ) MODBUS ADDRESS:40024
=0, this parameter can not be
( Default = 0 ) MODBUS ADDRESS:400
( Default = 0 ) MODBUS ADDRESS:400
.
and Parameters are observed if Operation type
o
( Alarm Latching Output is Selected )
Power
°C
Alarm
Status
Alarm
Output
Active
Led
Alarm
Output
is observed. In this
26
parameter.
=
Time
Time
Decrement
Button must
be pressed
to make alarm
output is
passive.
Time
Time
25
27
11