Lf-S8 - Tascam VL-A5 Bedienungsanleitung

LF-S8

1 POWER switch
This is used to turn the power on and off.
2 FUSE holder
This unit is equipped with a fuse. lf the unit does not
work, disconnect the power plug from the AC outlet and
then contact the nearest qualified service personnel.
3 ~ IN jack
This ~ IN jack is used to connect the supplied power
cord.
4 INPUT CH1/CH2 jacks
These balanced input jacks suit for both XLR balanced
and TRS PHONE balanced connectors, and are typically
connected to output jacks on a mixer.
5 CROSS FREQ knob
This control is used to set a cutoff frequency between 40
to 120 Hz to cut high or low frequency output from the
subwoofer.
6 OUTPUT CH1/CH2 jacks
These output jacks connect XLR balanced connectors.
High frequency signals are output through the jack (low-
frequency is cut according to the cutoff frequency set
with the CROSS FREQ knob). An external device such as
a power amplifier is connected to the jack.
When you use the LF-S8 with the VL-A4, VL-A5 or
VL-A8, connect both the left (CH1) and right (CH2)
INPUT jacks.
7 OUTPUT SUB LF jack
This output jack connects XLR balanced connector. Low
frequency signals are output through the jack (high fre-
quency is cut according to the cutoff frequency set with
the CROSS FREQ knob). The second subwoofer is con-
nected to this jack.
3-NAMES AND FUNCTIONS
Rear Panel
8 LEVEL CONTROL knob
This is used to adjust the output level of the subwoofer
speaker.
9 PHASE switch (0°/180°)
This is used to switch the output phase of the subwoofer
speaker. Depending on speaker placement, or the com-
bination of speaker systems, bass sounds may be heard
differently. If so, try to adjust the output phase using this
switch to make bass sounds better for you.
0 POWER indicator
This indicator lights up when the power switch is turned
on and AC power is supplied to the ~ IN jack.
Front Panel
TASCAM VL-A's
9