Troubleshooting - LENCO TCD-973 Bedienungsanleitung

FILE DELETE AT USB / SD CARD (BY REMOTE CONTROL)
THE SYSTEM IS ABLE TO ERASE THE FILE STORED INSIDE THE USB PEN DRIVE OR SD CARD BY
FOLLOWING:-
A) SINGLE FILE DELETE
1. PRESS AND HOLD THE " INFO " BUTTON FOR 3 SECONDS AND THE LCD DISPLAY (18) WILL SHOW (DEL
---001)
2. PRESS SKIP FORWARD
DELETE
PRESS THE " REC " BUTTON TO ENTER " YES / NO " MODE AND THEN PRESS
3.
FORWARD OR SKIP BACKWARD
PRESS THE " REC " BUTTON AGAIN TO CONFIRM THE SETTING.
4.
B) ALL FILE DELETE
1. PRESS AND HOLD THE " INFO " BUTTON FOR 3 SECONDS AND THE LCD DISPLAY (18) WILL SHOW (DEL
---001)
PRESS AND HOLD THE " INFO " BUTTON TO ENTER " YES / NO " MODE AND THEN PRESS
2.
FORWARD OR SKIP BACKWARD
PRESS THE " REC " BUTTON AGAIN TO CONFIRM THE SETTING.
3.
REMARK : ALL THE FILES INSIDE THE USB STORAGE MEDIA OR SD CARD WILL BE DELETED
COMPLETELY AFTER CONFIRMING TO " YES " MODE.

TROUBLESHOOTING

-DISPLAY DOESN'T SHOW ANYTHING:
-DISPLAY DOESN'T SHOW ANYTHING
WHEN SWITCHING THE SOURCE
SELECTOR:
-UNIT FREEZES COMPLETELY:
IF AT ANY TIME IN THE FUTURE YOU SHOULD NEED TO DISPOSE OF THIS PRODUCT PLEASE
NOTE THAT: WASTE ELECTRICAL PRODUCTS SHOULD NOT BE DISPOSED OF WITH
HOUSEHOLD WASTE. PLEASE RECYCLE WHERE FACILITIES EXIST. CHECK WITH YOUR LOCAL
AUTHORITY OR RETAILER FOR RECYCLING ADVICE. (WASTE ELECTRICAL AND ELECTRONIC
EQUIPMENT DIRECTIVE)
OR SKIP BACKWARD
TO SELECT " YES " OR " NO ".
TO SELECT " YES " OR " NO ".
PLEASE COMPLETELY REMOVE THE AC CORD FROM THE
WALL OUTLET AND WAIT AT LEAST 20 SECONDS BEFORE
PLUGGING IT IN AGAIN
PLEASE COMPLETELY REMOVE THE AC CORD FROM THE
WALL OUTLET AND WAIT AT LEAST 20 SECONDS BEFORE
PLUGGING IT IN AGAIN
OPERATE THE SOURCE SELECTOR SWITCH CAREFULLY,
SWITCHING TO FAST OR SWITCHING MORE THEN ONE STEP
AT A TIME MAY RESULT IN A MALLFUNCTION AGAIN
PLEASE COMPLETELY REMOVE THE AC CORD FROM THE
WALL OUTLET AND WAIT AT LEAST 20 SECONDS BEFORE
PLUGGING IT IN AGAIN
GB-7
BUTTON TO SELECT THE FILE GOING TO
SKIP
SKIP