Installing Windows - ASROCK FM2A75M-DGS Bedienungsanleitung

2.7 Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive fi rst. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom side
to install those required drivers. Therefore, the drivers you install can work properly.
2.8

Installing Windows

With RAID Functions
If you want to install Windows
HDDs with RAID functions, please refer to the document at the following path in the
Support CD for detailed procedures:
..\ RAID Installation Guide
RAID mode is not supported under Windows
2.9 Installing Windows
XP Without RAID Functions
If you want to install Windows
SATA3 HDDs without RAID functions, please follow below procedures according to
the OS you install.
2.9.1 Installing Windows
If you want to install Windows
please follow below steps.
AHCI mode is not supported under Windows
Using SATA3 HDDs without NCQ and Hot Plug functions (IDE mode)
STEP 1: Set up UEFI.
A. Enter UEFI SETUP UTILITY
Confi guration.
B. Set the "SATA Mode" option to [IDE].
®
STEP 2: Install Windows
ASRock FM2A75M-DGS Motherboard
®
7 / 7 64-bit / Vista
® TM
7 / 7 64-bit / Vista / Vista
®
7 / 7 64-bit / Vista
® TM
7 / 7 64-bit / Vista / Vista
®
XP Without RAID Functions
®
XP on your SATA3 HDDs without RAID functions,
Advanced screen
XP OS on your system.
TM TM
/ Vista 64-bit
TM
64-bit on your SATA3
®
XP.
TM TM
/ Vista 64-bit /
TM
64-bit / XP OS on your
®
XP.
Storage
21