Remington F3790 Bedienungsanleitung Seite 9

ENGLISH
TRIMMING
Push the trimmer button down
Place trimmer at desired trim line for a quick, easy, professional trim.
7 R UHWUDFW DQG VZLWFK RII WKH WULPPHU IROG WKH WULPPHU EDFN XQWLO LW ORFNV LQWR SRVLWLRQ
TIPS FOR BEST RESULTS
Ensure your skin is dry. Always hold the shaver at right angles to the skin so that both foils
are touching the skin with equal pressure. Use moderate to slow stroking movements. The
use of short circular motions in stubborn areas may obtain a closer shave, especially along the
neck and chin line. DO NOT hold the shaver at an angle whereby only one foil is touching the
skin. This will distort the foil and may cause the cutters to damage the foil.
DO NOT press hard against the skin in order to avoid damage to the foil.
CARE FOR YOUR SHAVER
Care for your product to ensure a long lasting performance. We recommend you
clean your shaver after each use. The easiest and the most hygienic way to clean the
shaver is by rinsing the product head after use with warm water. Always keep the
protective cap on the shaving head and keep the trimmer in the "off" position when
the shaver is not in use.
DRY CLEANING
Press the head release button to remove the head assembly. (Fig. H)
Thoroughly blow out the stubble from the foils and cutters.
Use the cleaning brush to sweep out the cutters. Do not use the cleaning brush on the
foils. Damage may occur to the holes of the foils. (Fig. I)
Replace head assembly
CAUTION:
Do not clean the shaving foil with the brush.
Do not remove or replace head assembly while shaver is running as it may cause damage
to the unit's foils and cutters.
To clean the external surfaces of the shaver, use a damp cloth.
Do not use strong detergents or other chemicals.
To dry, wipe the surface of the shaver with a dry towel.
Do not submerge the shaver in water.
REPLACING THE FOILS & CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that foils
and cutters are replaced regularly.
Signs that your foils and cutters need replacing:
090247_REM_IFU_F3790_22L.indd 3

19:33:12|17.04.09 Guido Krölls