Skytec LIGHT SHOW Kurzanleitung Seite 3

LIGHT SHOW
General
The light show consists of a number of loose lamp modules and a
control unit. The lamps are music controlled. The electronic
controller and the microphone are built in the controller. The set
includes coloured 230V 60W reflector lamps.
Installation and use
The light show can be used free standing in the supplied
configuration or in a random built shape. The modules are
interlockable. The modules are separated by pushing the lock
backwards and assembled by putting two pods side by side or by
stacking them and pushing the lock from the rear side into the rail.
Connect the lamp modules by plugging the Euro plugs from the
modules into the controller as follows:
Channel 1 - Connection 1 & 2
Channel 2 - Connection 3 & 4
Channel 3 - Connection 5 & 6
After having connected all modules you can plug the control unit
into a mains outlet.
Operation
Switch the unit on. Set the sensitivity via the rotary buttons on the
controller. The more the buttons are turned clockwise, the more the
lamps are sensitive to the rhythm of the music or any other sound.
Warning
- Only use the light effect for its original purpose.
- Only connect the supplied lamp modules to the control unit.
- Use reflector lamps of 60W max. If you use more powerful lamps,
they might overheat and cause fire.