When Using The Instrument - Metrix MX 670 Bedienungsanleitung

1.2.2 Meaning of symbols used
Symbol Meaning
Instrument protected
by double isolation.
Alternating current.
Direct current.
CAUTION -
DANGER! Refer to
the operating manual.
Caution, risk of
electrical shock
Audible continuity test
Clamp:
Application or
withdrawal authorized
on conductors under
dangerous voltage

1.2.3 When using the instrument

To prevent electrical discharge, injury or damage to the
device, and to ensure you use the multimeter without risk,
follow the safety
below:
•
Read the operating instructions fully before using this
device and observe all safety instructions.
•
This device must be used indoors, up to 2000 m altitude.
•
Never exceed the protection limit values indicated in the
specifications for each type of measurement.
•
When the multimeter clamp is inserted into the
measurement circuits, do
measurement cables or terminals.
•
Before changing the
measurement leads from the circuit measured.
•
Never measure resistances on a live circuit. Disconnect
the power and discharge all high voltage condensers
before performing a
measurement.
•
Avoid working alone.
•
Use the device only as specified in this manual;
otherwise, the protection provided by this multimeter may
be altered.
•
Do not use this device if it appears damaged.
•
Inspect the integrity of lead insulation. Replace damaged
leads.
•
Be careful when working with voltages higher than
70 V or 33 Vrms and 46.7 Vpp, such voltages can
DC
pose a risk of electrocution. Depending on conditions, the
use of individual protection is recommended.
•
keep
Always hands behind the physical protection of the
tips or the clamp during a measurement.
22
Symbol Meaning
Ground.
Battery.
The CE marking
guarantees
conformity with
European
directives and with
regulations
covering EMC.
Selective sorting
of waste for
recycling electrical
and electronic
equipment within
the European
Union.
In accordance with
the WEEE
2002/96/EC
directive: This
equipment must
not be processed
as household
waste.
recommendations
not touch the unused
function, disconnect the
resistance or continuity
MX670 / MX675