Putting Into Operation - Clatronic KRC 742 Bedienungsanleitung, Garantie

Assembly
Make sure that the plug is not inserted when assembling the
device.
NOTE:
• Remove all objects from the cupboard and anything which
is fragile in the adjacent cupboards.
• For the installation the cupboard must fulfi l the following
conditions:
Thickness of the cupboard fl oor between 16 and 20 mm.
• The wall mounting of the cupboard must be stable and
anchored fi rmly in the wall with at least 2 screws.
• Important! Do not install the device above a cooker!
• When installing the device it must be ensured that there is
a power socket within reach.
• The mains socket must be within easy reach, so that the
plug can be quickly removed in an emergency.
• Important! Do not connect the device to the mains power
supply until after installation!
• The device cannot be installed under cupboards under
which there is a lighting strip.
• This device can be attached using the screws supplied to
the underside of a wall cupboard, for example.
• First use the four screws to attach the mounting plate (15)
which is on top of the device and which is released from the
fi xing device by pressing strongly towards the rear.
CAUTION:
If other screws are to be used because the wall is not thick
enough, these screws may break through the cabinet in
certain circumstances!
• Now insert the radio into the assembly plate mounting plate
and press it to the rear until it locks in place.
Inserting the power reserve batteries
(not supplied)
If there is a power cut or the mains plug has been removed
from the power socket, the settings will be retained if the power
reserve batteries are inserted.
• Open the battery compartment (14) on the bottom.
• Insert 1 block battery of type 6 LR 61 6AM6. Ensure the
correct polarity. If the machine is not used for a prolonged
period, please remove the batteries in order to avoid „leaka-
ge".
CAUTION:
Do not dispose of batteries in the domestic waste. Please
return used batteries to the relevant collection points or the
shop where they were bought.
Never throw batteries into a fi re.
20
05-KRC 742 20

Putting into Operation

1. Insert the plug into a properly installed 230 V, 50 Hz power
socket. Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
2. Push the FUNCTION (RADIO ON / TIMER / AUTO) switch
(7) to RADIO ON.
3. Tune into the desired station using the TUNING regulator
(9).
4. If reception is too weak, try to improve it by changing the
position of the dipole antenna.
5. The volume can be adjusted with the VOLUME (MAX./MIN.)
knob (10).
6. In order to switch off the device, move the FUNCTION
(RADIO ON / TIMER / AUTO) switch to TIMER. The display
indicates furthermore the current opposed time.
Setting the Time
Hours: Press key 3 (TIME) and key 5 (HOUR) simulta-
neously until the desired hour is reached.
Minutes: Press key 3 (TIME) and key 6 (MIN) simultane-
ously until the desired minutes are reached.
Setting the Alarm
Hours: Press button 2 (ALARM) and button 5 (HOUR)
simultaneously.
Minutes: Press button 2 (ALARM) and button 6 (MIN)
simultaneously.
Press the ALARM button to see the set time in the display.
Radio alarm
• Once the alarm times are set and a radio station has been
selected, shift the function selector switch (7) to „AUTO". A
dot in the display (11) appears next to AUTO (12).
• As soon as the alarm time is reached, the radio is switched
on. The selected radio station plays at the set volume.
Buzzer alarm
• If you do not wish to be woken up by the radio signal you
can turn the VOLUME (MAX./MIN.) control all the way to the
right beforehand until it clicks into place. Push the function
selector switch (7) to the AUTO position.
• Instead of the radio, the buzzer goes off when the alarm
time is reached.
To turn off the alarm, push the FUNCTION (RADIO ON /
TIMER / AUTO) switch (7) to the TIMER position or press
button 2 (ALARM).
TIMER Function
The timer only works if the alarm is deactivated.
• First turn the function selector switch (7) to TIMER.
• Push the function switch (4) to ON. After 59 minutes or
1 hour and 59 minutes (press button HOUR) an alarm is
heard.
27.09.2006, 16:27:15 Uhr