10 Speaker
11
/
buttons (Radio scan / next / previous track)
12
/
buttons (volume)
13 PROG / MEM button (memory)
14 SNOOZE / SLEEP button
Back of Unit (not shown)
The following ports are covered by a rubber cover:
DC 9 V jack + indicator light for battery charge
AUX jack
USB port
Accessories (not shown)
Power adaptor
Start-Up of the Device
• Choose a suitable location for the device. Suitable would
be a dry, level, nonslip surface.
• Sensitive surfaces may be protected by plastic foil.
Remove this foil.
• Make sure the device is vented sufficiently!
• If necessary, screw the flexible antenna onto the correct
connection.
Power Supply (Adaptor)
1. Make sure the grid voltage corresponds to the figures on
the rating plate.
2. Flap the rubber cover down.
3. Plug the power supply unit into a properly installed protec
tive contact socket.
4. Connect the device with the plug connector by inserting
its plug into the "DC 9 V" jack of the device.
CAUTION:
• Only use the supplied power adaptor for this device. Do
not use for other devices.
• Only use power adaptor with 9 V (
tors may cause damage to the device.
NOTE:
Disconnect from mains power supply during longer periods
of nonuse.
Charge the Installed Battery
Before you can operate the unit with the installed battery, you
must first charge it.
1. Open the rubber cover.
2. Connect the unit to a socket with the mains adapter. The
indicator light below the DC socket lights up red and the
battery is charged.
When the battery is fully charged, the indicator light goes out.
Keep the cover closed when not in use.
CAUTION:
Never leave the unit unattended during charging.
BR836_IM_CTC_new2
NOTE:
• The duration of the charging process depends on the
state of charge of the battery.
• When the unit is out of use for long periods of time,
charge the battery at least every 6 to 12 weeks. The
battery also constantly discharges when the unit is
switched off.
• If the battery is almost empty, the unit will switch off. The
battery must then be charged as described above.
Turning the Device On / Off
Press the
NOTE:
Press and hold the
to switch the unit to the extended standby mode. In this
mode the time will not be shown in the display.
In order to switch the unit on again, press and hold the
button again for approx. 1 second. The time will be dis
played. Now you can switch the unit on by briefly pressing
the
button.
FUNCTION button (5)
For switching between FM, USB and AUX mode.
/
Adjust to your preferred volume level.
Delayed Shut-Off (SLEEP) (14)
The device automatically switches off when the selected time
is reached.
• Select the time by repeatedly pressing the SNOOZE /
SLEEP button after which the device switches off. Select
from: 120, 90, 60, 45, 30 and 15 minutes. The SLEEP
), other adap
indicator will appear in the display.
• Deactivating: The "OFF" setting deactivates this function.
NOTE:
Briefly press the SNOOZE / SLEEP button to show the
remaining time.
Setting the Time
1. Switch the device off.
2. Briefly hold down the
will start to flash.
3. You can make the adjustment with the
(11).
4. Press the
5. You can make the adjustment with the
6. Save the time, by pressing the
General Operation
button (4), to turn the device on and off.
button for approx. 1 second in order
Volume (12)
button (7) in standby. The hours
button once more. The minutes will flash.
button once again.
24.05.17
/
buttons
/
buttons.
11