Do not use both port types simultaneously. Transmitter and receiver must always be
connected via the same port type, meaning if you connect the transmitter to an S-
video port, you must also connect the receiver to such a port.
This radio transmission set is only suitable low-voltage video
and audio signals. Never connect high-level, high-energy signals
such as the loudspeaker output of an amplifier. Convince yours-
elf before connection by checking the operating instruction of
the device to be connected in this respect.
In cases of doubt contact a specialist.
If these instructions are not observed, the radio transmission
system or connected devices could be damaged.
If your devices do not have scart connections, use suitable adap-
ters, available from our product range or from a specialist shop.
Transmitter
Connect the scart plug of the AV
connection cable marked with „transmit-
ter" to the AV output of your AV source
device.
Connect the cinch plug of the AV connec-
tion cable with the sockets AUDIO IN and
VIDEO IN of the transmitter.
28
The transmitter is labelled "transmitter".
Note the colour-labelling on the plugs
and jacks:
Video = yellow
Audio right = red
Audio left = white
Operating Instructions
English