Technical Specifications - Clearaudio Balance Amplifier Bedienungsanleitung

6. Technical Specifications:

The correlation between published specifications and performance is unreliable.
Measurements of your amplifier yield excellent results by any standards. However, only
those specifications that apply to its actual operation are included here.
Rated power output:
Frequency response:
Signal to noise ratio
(main outputs):
Distortion factor:
Input impedance:
Gain:
Input sensitivity:
Power consumption:
mains voltage:
Overall dimensions (mm):
Connector complements:
Weight:
Warranty:
All specifications are subjected to change at any time, in order to improve the product
* Only if the warranty card is filled out correctly and sent back to clearaudio. Please see
Seite/Page 21
Balance Amplifier
2 x 50 W/ 8 Ω pure class A
2 x 94 W/ 4 Ω class A
1 x 160 W/ bridged mode 8 Ω
from 20 Hz to 20 kHz (- 0,2 dB)
100 dB linear
0,02 % with 1/10 power rating
balanced and single-ended 10 k Ω
34,4 dB
370 mV for full output power
250W (±5%) at idle,
150W (±5%) in standby
determined by the needs of country
(115 V or 230 V)
which the unit was manufactured for;
cannot be reset by dealer or user
435x220x270
four custom binding posts
two 3-pin XLR balanced input connectors
two RCA input connectors
30 kg
5 years *
without notice.
Point 5!
Bedienungsanleitung/Instruction Manual
 clearaudio electronic GmbH 2007