Front View And Operating Elements - Clearaudio Balance Amplifier Bedienungsanleitung

2. Front view and operating elements

LED „Overheat" lights up if the amplifier is overheating, at the same time
1
the speaker output will be shut down. If the amplifier cools down, it will be
switched on automatically.
LED „Short" lights up in case of overload (to small impedance from the
2
connected speakers).
LED „DC Out" lights up it DC voltage on the speakers output e. g. by a
3
damage of the amplifier, resp. short after power up the amplifier.
LED „Power" lights up when the amplifier will be switched on with the
4
„Standby/On"-power button.
LED „Standby" lights up if the power switch on the rear side if the amplifier
5
is in the standby-mode.
6
Switch „Standby/On" indicates „Standby".
7
LED „Bridge" lights up if the amplifier is used in the bridged mode.
Seite/Page 14
Balance Amplifier
1
2
3
5
4
6
7
Bedienungsanleitung/Instruction Manual
 clearaudio electronic GmbH 2006