Clearaudio BALANCE AMPLIFIER Bedienungsanleitung Seite 18

4.4. Mono-bridged symmetric:
Input selector (9) not pressed, mode selector (10) pressed.
The music-signal will be connected with the XLR-input (8) left channel,
connection to the speakers connect them with both red speaker output (12).
minus-
connection
to speaker
In the normal stereo mode please use the red and white speaker outputs for the left
and right channel.
If you use the amplifier in the mono-bridged mode, you must connect the
speaker with the red speakers output connectors, the plus connector is the
red connector from the left output and the minus connector is the red
connector from the right output, to speakers.
In the bridged mode, the impedance of the speakers should be
At next you set the connection to your speakers.
If all connections are fixed you can turn on the amplifier with the
"power" (13) switch on his back.
After the switch on, the amplifier would be in the „Standby" mode.
Seite/Page 18
9
12
not lower than 4
Damage of the fuses might occur!
Balance Amplifier
Bedienungsanleitung/Instruction Manual
8
10
12
Ω
!
 clearaudio electronic GmbH 2006
plus-
connection
to speaker
13