Software - VOLTCRAFT PL-135 HAN Bedienungsanleitung

b) Airflow cross sectional area
1. Navigate to the menu item AREA and push the ENTER button (7). The four digits in
the lower half of the display (13) begin to flash.
2. Repeatedly push the MAX MIN button (9) to set the number of decimal places.
3. Confirm your selection with the ENTER button. The last digit flashes.
4. Change the value with the MEAN (11) and FLOW TEMP (8) buttons.
5. Confirm your selection with the MAX MIN button. The second last digit flashes.
6. Set the airflow cross sectional area value as described above and confirm the
selection with the ENTER button.
The value remains set even after shutdown.

11. SOFTWARE

a) Installation
1. Insert the CD into the corresponding drive of a computer.
2. Should the installation program not open automatically, open the file INSTALLER.exe
from the CD.
3. Follow the instructions on your screen.
Click the button Software to install the software.
Find out whether your operating system is 32 or 64 Bit. Then click either Driver 32
or Driver 64 accordingly to install the USB driver.
34