Sailor plus SA-123 DAB+ Bedienungsanleitung Seite 40

To select an option press and hold the MENU/SELECT button for about 5 seconds, until 'DAB
Station list' displayed on the LCD.
Note: Press the MENU/SELECT button again to confirm the current operation.
Press the TUNE -/+ buttons to display the option you want. There are 3 options as described below.
• Alphanumeric
This is the default setting. The stations are arranged in numerical then alphabetical order.
• Ensemble
This option sorts the list by the ensembles are in.
• Valid
This option sorts the list by whether the station is currently marked as being valid.
Manual Tune
It is possible to manually tune to a specific channel/frequency and add this to the station list.
This function can be used to assist the positioning the antenna to obtain the optimum reception for a
specific channel/frequency.
Press and hold the SELECT/MENU button for about 3 seconds, then press the UP or DOWN button
to display 'Manual tune', press the SELECT/MENU then press UP or DOWN to select desired
frequency, Press the SELECT/MENU button. A rectangle will be displayed on first line of the display.
The position of this rectangle indicates the signal strength, i.e the further towards the right the greater
the signal strength.
5 A 1 7 4 . 9 2 8 M H z
□
Adjust the position of the antenna to obtain the optimum signal strength.
Press and hold SELECT/MENU button for about 3 seconds, the LCD appear STATION LIST, then
press SELECT/MENU to enter normal DAB listening mode.
Dynamic Range Control (DRC)
DRC adds or removes a degree of compression to compensate for the differences in the dynamic
range between radio stations. For example, when a station is broadcasting popular music, may has a
high level of compression applied since the emphasis is on a constant high listening level, whereas a
station is broadcasting classical music, will has a little or no compression as the listener requires all
of the highs and lows in the music to define the detail.
There are three levels of compression:
• DRC off
• DRC high
• DRC low
Press and hold the SELECT/MENU button. 'Station list' will be displayed.
Press the UP/DOWN buttons until 'DRC' is displayed.
Press the SELECT/MENU button.
*
A symbol " " will be shown on Line 1 and the current DRC level will be displayed on Line 2.
No compression applied.
High compression applied (this is the default).
Low compression applied.
Page 6