Inhaltsverzeichnis
Werbung
Connection to the Telephone Network
Telephone socket
Telephone receiver adapter
Pull out the connecting cable of your telephone receiver on the tele-
phone receiver. Into socket which is now free you insert the includ-
ed telephone receiver adapter with the spiral cable. Insert the cable
of your telephone receiver into the narrower socket of the telephone
receiver adapter. Into the wider socket of the telephone receiver
adapter you insert the included telephone cable and connect it with
the LINE IN socket of the call recorder.
Set the switch for voice control VCS (Voice Control System) to ON.
(See chapter: Recording of telephone conversations). Take off the
telephone receiver and check whether you can hear the dialling
tone. If you cannot hear the dialling tone, your telephone is not suit-
able for the connection of the call recorder. The reason for this is
that there is no universal norm for the connection of telephone
receivers. Restore the original cable connection.
22
Listening via headphones
You can connect a mono headphone with a 3.5mm jack plug to the
EAR jack. The built-in speaker is switched off when operated with a
headphone.
Protection against accidental erasing of cassettes
Cassettes have protection tabs at the back against accidental erasing.
If you want to avoid that a cassette is accidentally erased, press the
protection tabs inwards with a screwdriver and break the tabs off. As
a result, the recording button RECORD can no longer be activated.
Changing of Batteries
To open the battery compartment lid press the marking on the bot-
tom of the device with your thumb or index finger and slide the lid to
the side with slight pressure.
Insert 4 mignon cells 1.5V (AA, LR6, UM-3) into the battery compart-
ment with correct polarity (see marking next to the battery compart-
ment). Make sure that the lift-out ribbon is placed underneath the
batteries, to make the removal of the batteries easier. After inserting
the batteries close the battery compartment again with the battery
compartment lid.
Changing of batteries becomes necessary when distortions of sounds
appear or when the magnetic tape no longer runs at the correct speed.
Tip:
Remove weak batteries straight away to avoid leakage which can
cause damage. Only use battery of recommended types.
Use alkaline batteries to achieve maximum possible operation.
27
Werbung
Inhaltsverzeichnis
