PIXO C1.1 Bedienungsanleitung Seite 15

Caution!
Do not charge generic dry batteries! Danger of explosion!
Charge only high quality and fast rechargeable batteries.
Damages from leaked and low quality batteries are out
of guarantee!
Li-Ion / Li-Po charge process
All Li-Ion battery packs have at least two or more
contacts. For the charging process you will need only
the contacts with the positive pole and the negative
pole. The positive and the negative pole are marked
on the battery pack. The other contacts are not needed
for the charge process and should not be used. The
charger detects the polarity and the battery voltage
automatically. You do not have to worry about the right
polarisation. You only have to make sure of full contact.
The Pixo C1.1 has a short circuit protection for Li-Ion
batteries.
1. Fix the battery pack provisionally in the snap-in
support. The battery pack can be inserted from the
horizontal left side, from the horizontal right side or
vertically to be fi xed on top of the battery charger
contacts. Position is at 0 degree, 90 degrees or 180
degrees. The battery contacts must be lined up in
the direction of the battery charger contacts.
2. Battery charger contacts must be adjusted to the
distance between the battery pack positive and ne-
gative poles.