Using The Gigavideo80™ Set; Frequently Asked Questions - Marmitek GIGAVIDEO80 Gebrauchsanleitung

TV Out
(S-video) S-video composite video adapter (art.no.09388
Figure 6
This standard adapter does not fit on all PCs. In that case, please contact the supplier of the
graphics card. To use the TV-out some settings in the graphics card menu need to be
changed. This is different for each PC and operating system, but usually the correct mode
needs to be selected. Select 'composite', 'CVBS' or 'PAL-G'. More information can usually be
found in the PC manual or graphics card manual. Because there are so many different types
of graphics cards, we cannot offer any support.
To transmit sound, you can use the audio out on the sound card of your PC. Please use an
adapter to convert the 3.5mm plug to a double RCA connection.
8. USING THE GIGAVIDEO80™ SET.
1. Make sure your A/V device is switched on.
2. Switch the receiving TV over to the TV transmitter going with the A/V input you plugged
the receiver into. Normally done by using the 0 or A/V button. The picture should now
automatically be there. No tuning is required.
3. Then you can control your A/V device with your own remote control by pointing it at the
IR window of the receiver or the IR window of your A/V device.
4. 2 external A/V devices can be connected to the transmitter.
Selecting the source:
Using 'TV2' (connected to the receiver), you can change sources by pressing any button
of a remote control for at least 8 seconds (e.g. of your TV or A/V device).
Using 'TV1' (connected to the transmitter), you can change sources by pressing the
SOURCE button (on the front of the transmitter) until the device reacts.
Independent of the signal on 'TV1' you can select a signal for 'TV2'.

9. FREQUENTLY ASKED QUESTIONS.

I get no signal.
• Check that the units are connected to mains and that the Power-switch is in the ON position
• Check that both units in the 'ON' position (figures 3 and 4) [B].
• Check if the receiving TV is on the correct A/V channel. Raise the small black side
antenna [J] to an upright position.
6
Marmitek
Figure 5
© MARMITEK