Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
Always turn off the device to be connected before plugging it into the
USB connection (1).
make sure the connection is correct. If the product is not connected properly,
it could overheat or cause an electric shock or fire.
make sure that your device meets the product's power requirements (see
technical data).
a) Inserting and exchanging adapters
1. Choose one of the included adapters (5, 6, 7, 8) and insert it correctly into the adapter
plug-in position (3) on the bottom of the USB power adapter. It is only possible to connect
in one way.
2. Push the adapter toward the locking lever (4) until the adapter clicks into place.
3. To remove the adapter, push down the locking lever with a tool (i.e. screwdriver or a pen
tip). Then push the adapter away from the locking lever to remove it.
4. Follow the same steps to insert another adapter.
b) connection
1. Connect your USB device (make sure it is off) to the USB connection (1).
2. Connect the USB power adapter plug (5, 6, 7, 8) to a common household power outlet. The
power indicator (2) lights up to indicate that the USB power adapter is operational.
3. The connected USB device is now charging. Should you wish to operate the USB device,
you may turn it on now.
4. Turn off your USB device before unplugging it from the USB power adapter.
5. Disconnect the USB power adapter from the power outlet after use.
cLEANING AND cARE
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical
solutions as they can cause damage to the housing and malfunctioning.
• Before cleaning, disconnect the product from the power supply and from any connected
device.
• Never submerge the product in water.
• There are no components located inside the product you need to maintain. Never open/
dismantle the product.
• To clean the product, a dry, soft and clean cloth is sufficient. Do not apply too much
pressure to the housing to prevent scratching.
• Use a longhaired, soft and clean brush and a vacuum cleaner to easily remove dust.
DISPOSAL
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the relevant
statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
TEchNIcAL DATA
Input voltage / current ........................... 100 – 240 V/AC, 50/60 Hz, 260 mA
Output voltage / current ........................ 5 V/DC, 2400 mA
Output power (total) .............................. max. 12 W
Standby power consumption.................<0.3 W
Protection class.....................................II
Operating conditions ............................. 0 to +40 ºC, 20 – 85 % RH (non-condensing)
Storage conditions ................................ -20 to +60 ºC, 10 – 90 % RH (non-condensing)
Dimensions (W x H x D) ....................... approx. 79 x 54 x 77 mm
Weight .................................................. 131 g
Legal notice
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© copyright 2014 by conrad Electronic SE
Werbung
Inhaltsverzeichnis
