Miscellaneous
•
The product is not a toy and should be kept out of reach of children and pets!
•
On commercial premises, the accident prevention regulations of the Association of Industrial Professional
Associations with respect to electrical systems and operating equipment must be observed.
•
In schools, training centres, Hobby and DIY workshops, the handling of measuring appliances must be
responsibly supervised by trained personnel.
•
Repair works must only be carried out by a specialist/ specialist workshop.
•
If you have queries about handling the device, that are not answered in this operating instruction, our technical
support is available under the following address and telephone number:
Voltcraft
®
, 92242 Hirschau, Lindenweg 15, Germany, phone 0180 / 586 582 723 8
22
5. Remplacement des piles
Lorsque l'icône de piles faibles apparaît, ,
, sur l'écran d'affi chage (3), remplacer les piles.
1.
Éteindre le testeur à l'aide du bouton « ON/OFF » (9) et enlever toutes les piles en cours de test.
2.
Ouvrir le compartiment à piles (10).
3.
Insérer deux piles bouton LR44/AG-13/L1154 dans le compartiment à piles (10) en respectant la polarité (« + » = positif). La
borne positive de la pile bouton doit être tournée vers la gauche.
4.
Fermer le compartiment à piles (10).
6. Fonctionnement
Il faut sortir les piles à tester de leur appareil avant la mesure.
1.
Mettre le testeur en marche à l'aide du bouton « ON/OFF » (9).
2.
Appuyer sur le bouton « MODE/START » (4) pour régler la tension voulue pour le test des piles. L'indicateur de choix de
tension clignotera.
39