AEG DK11 Montageanleitung Seite 4

EN
Dear customer,
this discharging kit will allow your tumble dryer to discharge the condensation water produced
during each drying cycle directly into the nearest drain, without your having to empty out the
tank at the end of the cycle.
Important!
The operation described below must be carried out before completing the stages of the entire
installation of the tumble dryer.
Open the door of your tumble dryer, and extract from the drum the bag that contains the
1
following items of the discharging kit:
● a nylon band;(5)
● a 90° fitting for connecting the draining hose;(3)
● a plastic curved part to be used for discharging into a sink;(2)
●
a plastic anchoring support for fastening the draining hose to the back of the
machine;(4)
● 2,5 metres of semi-transparent hose;(1)
● a gasket.(6**)
Position the tumble dryer so its back is towards you.
2
At the top right you can see a red hose which comes out of the back and is fastened to
3
a plastic fitting.
Using a pair of pliers, loosen the metal band and push it down, in order to be able to
extract the red hose from the plastic fitting.
Take the 90° fitting that has been supplied and insert it into the red hose.
4
Insert the plastic anchoring support that fastens the draining hose to the back, then
5
connect the other end of the draining hose to the 90° fitting.
6
Using the nylon band, fasten the red hose to the fixed fitting on the back.
By means of a 7-mm socket spanner, unscrew the screw shown in the figure from the
6*
back. Insert the screw you have removed into the relevant seat on the plastic anchoring
7
support, and tighten the screw, positioning the draining hose as shown in the figure.
If necessary, shorten the draining hose. If you wish to discharge the condensation water
8
into a sink, you will have to apply the plastic curved part to the draining hose, in order
to be able to hang it on the edge of the sink.
Important!
9
Do not hang the curved part at a height exceeding 1 metre, and suitably shorten the
draining hose so as not to create a bend higher than 0.5 metres, as shown in the figure.
* Dryers with Steam Technology
** only with kit 12512251/