Control Elements On The P8 Front Panel - Quadral AURUM M8 Bedienungsanleitung

• Never use the equipment in the vicinity of water, in humid areas or outdoors. Mois-
ture can bypass the electrical insulation and this will create a life-threatening risk
as is the case with all equipment that has not been specially designed against
the penetration of moisture.
• Protect the equipment against water being sprayed on it. You must also ensure
that no vessels containing liquid (e.g. vases) are placed on top of the equipment.
• Do not place the equipment in the vicinity of a heat source such as an electric
fire, radiator, oven or similar.
• The slits and openings in the enclosure provide the ventilation and ensure reliable
operation. They must never be misaligned or covered.
• Burning-out of specific components cannot be completely excluded, despite the
use of protective devices, if the equipment is severely overloaded by continually
using very loud sound levels. A fire might also be caused inside the equipment in
theory, as a result of this type of overloading. Therefore the amplifier should always
be used within its limits and it should not be left unattended.
• Only our technical service should undertake the maintenance of your equip-
ment. Maintenance will be necessary if any type of damage occurs, i.e. if the
power cables or plugs are damaged, if an object falls on the equipment, if the
equipment is dropped or if liquid seeps into it. Never open the equipment as you
might touch the mains voltage (230V / 115V), which is dangerous.
• Only use furniture and other units for attaching and putting the equipment on
that can be obtained from or are recommended by the manufacturer. You must
ensure that moveable tabletop units or shelves on which the equipment will be
placed are always moved very carefully in order to prevent damage or injuries
from being caused if the equipment tips over.
• Continuously loud volume can damage your hearing!
• Only use a dry, soft cloth to clean your equipment.
• Keep the packing for possible transportation use later on and keep the plastic
bag well away from children, due to the risk of asphyxiation.
16

Control elements on the P8 front panel

1 2
1 Volume control (Volume): With this rotary control is used to set the volume. The
settings are changed in 1dB increments and are shown in the display.
2 Infrared Receiver: This sensor receives the infrared signals of your remote control.
Always point the remote control at this area, and make sure that the sensor is not
covered up.
3 Display: Here, pieces of status information are displayed that facilitate the
handling of the amplifier.
4 Input Selection (Source / Menu): You may choose the source here by turning
the button left or right. The current source is shown in the display. By pressing the
button, you may access the menus. (Balance/Bass/Levels/SIS/HP). One rotation
of the button within the respective menu item changes the setting.
5 On/Off Button: Press this button to turn the P8 on. Press this button again to turn
the device off (standby). In standby operation, all of the settings remain saved.
6 Operating Display: This display will light up blue if the device is in standby mode
and thus signalizes that you may turn the device back on at any time by pressing
button (2) on the remote control.
Note:
The SIS function serves the purpose of automatically switching off the device
after approx. 15 minutes in case the device does not receive any signal. (Default
setting = Off) If the SIS function is activated on the P8 pre-amplifier and there is a
LINK connection to the M8, then the M8 power amplifier is also switched off.
If there is a LINK connection between P8 and M8, pressing button 5 on the pre-
amplifier, the M8 power amplifier is switched on or off as well.
3 4 5 6
17