Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

cooking WaffLeS

1. Connect the product to the power supply. Both the green
ready light and the red control light turn on and showed that
the product is connected and heating up (fig. 1). Once the
product is heated up, the green light will turn off. The red light
is steady on and shows that the product is ready to use.
2. Before cooking, apply a small amount of oil to the coated
cooking surfaces.
Warning: Do not apply using sharp/pointed objects; this may
damage the non-stick coating on the upper surface.
3. Put 1 wooden stick (included) into the middle of each waffle
form (fig. 2). Evenly distribute the waffle mixture across the
lower cooking surface (fig. 3). If necessary, increase or
reduce the quantity of mixture for the next waffle. Take care
not to let the mixture run over the sides of the cooking
surfaces.
4. Close the lid to cook.
5. After approx. 3 minutes, carefully open the lid to check the
cooking progress.
6. The waffles will be ready after approx. 5 minutes.
7. Use a heat-resistant plastic or wooden spoon to remove the
waffles.
Warning! Do not use your fingers to remove the waffles as
they could get burnt.
8. Wipe the cooking surfaces if required with some kitchen towel
(and a little cooking oil).
Warning – risk of burning!
The cooking surfaces are very hot. Be careful not to burn your
fingers.
9. Unplug the cable from the power supply if you have finished
cooking or are leaving the room.
10. Allow the product to cool before cleaning.
11. finally, clean the product.
SW-230W6_A5_170718.indb 13
Fig. 1
Fig. 2
Fig. 3
13
18/7/17 9:19 am

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis