Disposal Of Packaging Materials; Inserting Batteries; Attaching The Connector Plug; Placement Of The Floor Mat Underlay - lidl TMA 2 A1 Bedienungsanleitung

Disposal of packaging materials

GB

Inserting batteries

♦
♦
♦

Attaching the connector plug

♦
Placement of the floor mat underlay
Placement as an alarm or visitor warning
♦
♦
6
The packaging protects the appliance from damage during carriage.
The packaging materials have been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
Returning the packaging to the material cycle conserves raw materials and
reduces the amount of waste which is generated. Dispose of packaging materials
that are no longer needed in accordance with applicable local regulations.
Push the battery compartment cover
downwards.
Insert the four AAA batteries
Ensure the +/- terminals are correctly aligned.
To close the battery compartment cover
of the signal emitter .
Connect the connector plug
plug of the signal emitter
the wires together until they snap into place.
Place the floor mat underlay
on use. The floor mat underlay
exposed to rain or water.
NOTICE
► Take into account the distance between the floor mat underlay
signal emitter . The cable length of the signal emitter
Select the area, e.g. in front of an entry door, in front of a patio door or above or
below a staircase, that you want to secure.
Cover the floor mat underlay
on the front of the signal emitter
(supplied) into the battery compartment.
, push it back upwards on the front
of the floor mat underlay
. To do this, join the connectors on the ends of
either inside or outside of the building, depending
is intended for use in a dry area. It is not be
completely with a carpet or a welcome mat.
to the connector
and the
is approx. 10 m.
TMA 2 A1