Placement Of The Signal Emitter; Installing The Signal Emitter - lidl TMA 2 A1 Bedienungsanleitung

CAUTION
► The appliance may not function correctly if the ground is very uneven.
► Do not use rigid carpet or foot scrapers as the floor mat underlay
to selective pressure.
► Always use the floor mat underlay
Never lay it out on sharp objects, such as gravel, as this may lead to a
malfunction and damage to the floor mat underlay
► If you use the floor mat underlay
mat underlay

Placement of the signal emitter

NOTICE
► Take into account the route of the cable.
You can install the signal emitter
or at any distance of up to 10 m.
CAUTION
► The cable must not be clamped over sharp edges. Protect the cable with
electrical tape if necessary.
WARNING
► Fit the cable so that it does not present a tripping hazard.

Installing the signal emitter

The signal emitter
it on the wall.
For a wall mounting, proceed as follows and use the included 2 wall plugs
and 2 screws
♦ Use a pencil to mark 2 drill holes at a distance of approx. 44 mm above each
other on the wall.
♦ Drill holes at the marked positions with a diameter of 5 mm and a depth of at
least 25 mm.
♦ Push the wall plugs
♦ Screw in the screws
hooked onto them.
♦ Hang the signal emitter
TMA 2 A1
initially for a few hours in a warmer environment.
in the direct vicinity of the floor mat underlay
may be placed free standing/lying down or you can mount
:
into the drilled holes.
only far enough so that the signal emitter
onto the screws.
fully laid out on a flat surface.
.
in a cold environment, lay out the floor
GB
reacts
can still be
7