Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Congratulations, you have purchased a shower "SHOWER PLATE"
to enhance your bathing experience in your garden. The installation
of this shower is done in a few minutes and requires no tools.
Installation
Place the shower plate on a stable and horizontal surface.
Connect the green adapter to the platform (Figure 1 and 2). Check
the valve of the adapter that controls the water flow is in ON posi-
tion (Figure 3)
Connect the garden hose (Figure 4)
Open water source to 75% of maximum flow. If you need higher
water height increase the water flow. However, if the pressure is
too high, the adapter might disengage from the platform.
To test water height step onto center of platform, your weight will
open the spray valves. If water height is too low go back to water
source and open your water valve more. To lower the water
height, adjust the valve on green adapter.
During hot days, release some water from the garden hose before
connecting to the platform to avoid getting burned.
In winter you MUST empty completely the shower, and if you are
unsure, we recommend to store the shower inside your garage.
For normal use, the pressure of your water should be minimum 2
bars. For a pressure above 4 bar, please use a pressure reducer.
Steinbach VertriebsgmbH,
Aistingerstrasse 2, 4311 Schwertberg, Österreich
FR/IT/CZ/HU/HR/SK/SLO/RO/BG/TR: +43 (0) 7262 / 61431-0
e-mail: service@steinbach.at
www.steinbach.at
Bodendusche Jump On | 2013_V1
Page 3 of 4
Werbung
