Installation Manual; Unpacking; Assembling The Shredder; Operation - FLORABEST FLH 2800 A1 Betriebsanleitung

GB
the same or a similarly qualified person in
order to prevent hazards.
• Do not use the appliance if the on/off
switch does not work properly. Always
have a damaged switch repaired by our
Service Centre.
• Only use extension cables that have been
approved for outdoor use and are resist-
ant to splash water. The core diameter for
extension cables measuring up to 25 m
must be at least 2.5 mm², and 2.5 mm²
for cables longer than 25m. Always roll
the whole cable off the reel before use.
Check the cable for damage.
• Do not unplug the shredder by the cable.
Keep the cable away from heat, oil and
sharp edges.

Installation manual

Unpacking

1. Remove the shredder from the
packaging.
B
2. Pull the collector box (2) out of
the chassis (12) and take out the
shredder unit and accessories.
3. Check the scope of delivery.

Assembling the shredder

C
Assemble the two running wheels
1
(1). Clip in the wheel covers into
the running wheels.
Screw on the two adjustable feet
2
(13) to the chassis (12).
Fix the cutting attachment (4)
3
onto the chassis (12) with the four
screws enclosed.
4. To insert the collector box
( 2), the safety switch(see pic-
A
ture ) must be unlocked, i.e. in
D
the "OFF" position. Push the col-
lector box (
36
2) into the chassis (
A
11), with the safety switch (
A
3) on the side of the wheels (
1). The collector box (
be pushed in only in one direc-
tion.
5. Lock the collector box (
pushing the safety switch (Fig
) to the ON position.

Operation

Start-up

Before starting the shredder, make sure that
the shredder unit is firmly attached to the
chassis and the collector box and safety
switch are in their proper positions (Fig
The shredder cannot be switched
on before the collector box and
safety switch are in their proper po-
sitions.
Switching the shredder on and
off
Make sure that the mains power
voltage agrees with the type plate
on the shredder.
Make a loop at the end of
the extension cable and
hang the loop onto the strain
relief on the mains cable (
A
Connect the extension cable.
Make sure that the funnel feeder is empty.
1. To switch on, push the operating mode
selection switch (
and turn the operating mode selection
switch to the right.
2) can
A
2) by
A
5).
9) lock forward
A
A
A
D
).
D