Putting Into Operation; Safety Instructions - Kompernass E-4574 Bedienungsanleitung

. Placing the natural-stone water cascade
Place the natural-stone cascade on a level, scratch-resistant
and non-slippery surface.
Do not place the natural-stone water cascade on surfaces that
may be damaged by moisture (e.g. furniture, electrical equip-
ment, such as TVs, Video Recorders etc).
. Putting into operation
When the assembly is finished and a suitable place for the natu-
ral-stone water cascade was selected, it is ready for use. Insert the
plug. Your natural-stone water cascade is in operation now.
. Safety Instructions
Warning!
To prevent the danger of an electrical shock, do
not expose the connecting cable or the mains plug
to moisture or dripping water!
IRL
 | Operating Instructions
Attention!
Never leave the natural-stone water cascade unattended
during operation, this to ensure that in the case of malfunc-
tions the power supply is disconnected.
It is most important to check the water level in the water tank
during operation! A low water level may cause overheating
to damage the water pump! If the natural water pump is in
operation and the water level in the water tank is too low,
overheating may cause damage to the water pump!
Do not use your natural-stone water cascade on a low wa-
ter level. Make sure that the pump will always be covered
by water.
If the water tank has a low water level and the pump is not
completely covered by water while the natural stone cas-
cade is in operation, please unplug the transformer and fill
the water tank with distilled water up to the "MAX" mark
before starting again.