Safety System; Preparing The Product For Use; Switching On / Off / Selecting The Temperature - Silvercrest SWC 100 A1 Bedienungsanleitung

Important safety instructions / Safety system / Preparing the product for use
Avoid damage to the heated
shawl / wrap!
Please ensure that you:
· Only connect the heated shawl / wrap to the
voltage indicated on the label,
· only use the heated shawl / wrap in conjunc-
tion with the control
heated shawl / wrap (label),
· do not switch the heated shawl /
wrap on if it is folded or bunched
up,
· do not squeeze or jam the heated shawl / wrap,
· do not cause any sharp creases in the
heated shawl / wrap,
· do not place any objects, e.g. suitcase or
washing basket, on the heated shawl /
wrap when it is switched on,
· do not place any source of heat e.g. a hot
water bottle or similar items onto the warp
when it is switched on.
Ignoring this advice may damage the heated
shawl / wrap.
Do not cover the control
it on the heated shawl / wrap when the heated
shawl / wrap is in operation. The electronic
components in the control
shawl / wrap cause the control
slightly during operation.
Do not pull, twist or crease the cables. Ignor-
ing this advice may damage the heated
shawl / wrap.

Safety system

Note: the heated shawl / wrap is equipped with a
safety system. The electronic sensor technology
prevents the entire surface of the heated shawl /
wrap from overheating by automatically switching
off in the event of a fault.
If the safety system switches the heated shawl /
wrap off automatically as a result of a fault, the
function display on the control
light up, even when heated shawl / wrap is
switched on.
90862_silv_Waermecape_content_LB3_GB_SE_SK_DE.indd 9
indicated on the
1
and do not place
1
of the heated
1
to heat up
1
will no longer
1
Please note that, for safety reasons, the heated
shawl / wrap must not be used after a fault and
must be returned to the service address
indicated.

Preparing the product for use

Note: The heated shawl / wrap may smell of plas-
tic the first time you use it, but this will disappear af-
ter a short period of time.
Lay the heated shawl / wrap over your shoul-
ders in such a way that the dark side is facing
your body.
If necessary, fasten the press studs
front side (fig. B). There are additional press
studs in the arm region (fig. B).
5
To begin, first connect the control
warp with the plug-in connector
Switching on / off /
Selecting the temperature
Switching on:
Set Level 1, 2, 3, 4, 5 or 6 on the control
switch the heated shawl / wrap on.
Note: The function indicator
after the heated shawl / wrap is switched on.
Switching off:
Set Level 0 on the control
heated shawl / wrap off.
Note: The function indicator
illuminate.
Selecting the temperature:
Just before using the heated shawl / wrap, set it
to the highest temperature setting (level 6). This
will cause the heated shawl / wrap to warm up
quickly.
If you wish to leave the heated shawl / wrap
on for several hours, set the lowest temperature
(level 1).
on the
4
to the
1
(see fig. C).
3
to
1
illuminates
2
to switch the
1
ceases to
2
GB 9
07.05.13 11:22