Operating - Ideen Welt GYS-1 Bedienungsanleitung

Operating

Inserting Drill/Screw Bits
Insert desired screw bit/drill bit into the chuck (11).
Turning the Unit On/ Off
Press the switch (10) to start the machine, release it to stop.
Fastening and removing
• To fasten screws, press on of the switch (10).
• To remove screws, press on of the switch (10).
Please Note:
When fastening and removing screws do not place the tool on the screw head until the chuck has
come to a stop. Make sure to use the correct screw bits for the respective screw heads. Incorrect
handling and wrong screw bits will damage the screw.
If necessary, use a sample workpiece to determine, which torque setting is correct in your case.
Turning on the Light
The device is equipped with a light. Push the switch (3) forward to turn the light on. Push it back to turn
the light off again.
20
GYS-1_4305615249742_120815.indb 20 17/8/12 11:57 AM