Zulassungsbestimmungen - MED-EL RONDO Benutzerhandbuch

Technische Daten

Zulassungsbestimmungen

Gilt nur für Kanada:
Model: FineTuner – Canada 310
This Category II radiocommunication device complies with Industry Canada Standard
RSS-310. Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
Ce dispositif de radiocommunication de catégorie II respecte la norme CNR-310 d'Indus-
trie Canada. L'utilisation de ce dispositif est autorisée seulement aux deux conditions
suivantes : (1) il ne doit pas produire de brouillage, et (2) l'utilisateur du dispositif doit
être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est sus-
ceptible de compromettre le fonctionnement du dispositif.
Gilt nur für USA:
Model: FineTuner – FCC ID: VNP-FT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications made to this equipment not expressly approved by
MED-EL may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. lf this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• lncrease the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
62
Please note that this file is an uncontrolled electronic copy of product labelling
and should only be used for personal reference. The file must not be reproduced
or used for printing purposes. The content within this file is subject to change
without prior notice. For the most recent version of the file contact MED-EL directly.
This version was issued 2017-12-27 [YYYY-MM-DD]
NOT FOR PRINT