Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
List field TYPE to select the filter type
Input/Indication field FREQ for the filter
frequency (enter values in Hz)
Input/Indication field Q/BW for the qual-
ity factor/bandwidth (click Q or BW to
change between quality factor and band-
width)
Input/Indication field GAIN for filter
boost/attenuation
High pass filter HPF: input/indication
field for the cut-off frequency (enter val-
ues in Hz, "Off" < 20 Hz)
High pass filter HPF: list field to select
the filter type
Low pass filter LPF: input/indication field
for the cut-off frequency (enter values in
Hz, "Off" > 20 kHz)
Low pass filter LPF: list field to select the
filter type
Switch MUTE to mute the correspond-
ing output (same effect as )
Switch INVERT for phase inversion
Button COMPRESSOR to call up the
configuration window for the compres-
sor of the corresponding output
(
chapter 8.6)
Rotary knob DELAY with input/indica-
tion field for adjusting the signal delay of
the corresponding output; select the
measuring unit from the list field: time or
distance (for automatic calculation of the
sound delay time)
Level LIMITER: rotary knob THR with
input/indication field for the threshold
value
Level LIMITER: rotary knob REL with
input/indication field for the release time
View X-OVER
⑩
8.5 View X-OVER (fig. 10)
Buttons to go to a different view
Curve diagram of the magnitude fre-
quency response for all high pass filters
and all low pass filters
When a crossover network is created, all
three outputs are represented in a dia-
gram so that the frequency crossovers
are easy to identify. (When the outputs 2
and 3 are linked, only two filter curves
are shown.)
The cut-off frequencies of the filters
are represented by triangular markings
above the curve. To change the fre-
quency, move the corresponding mark-
ing with the mouse (as an alternative to
the numeric input in /).
High pass filter HPF: input/indication
field for the cut-off frequency (enter val-
ues in Hz; "Off" < 20 Hz)
(same effect as )
High pass filter HPF: list field to select
the filter type (same effect as )
Low pass filter LPF: input/indication field
for the cut-off frequency (enter values
in Hz, "Off" > 20 kHz) [same effect as ]
Low pass filter LPF: list field to select the
filter type (same effect as )
Input/Indication field G (gain) for adjust-
ing the volume of the output (same effect
as and )
Input/indication field D (delay) for ad-
justing the signal delay of the output
(same effect as )
Level indicators for the outputs
Switch LINK to link the outputs 2 and 3
(same effect as )
Switches MUTE to mute the correspond-
ing output (same effect as )
Switches PHASE INVERT for phase
inversion of the corresponding output
(same effect as )
8.6 Window COMPRESSOR
Compressor configuration window
⑪
Button BACK to return to the previous
view
Level indicator VU and gain reduction GR
Rotary knob "Threshold" with input/indi-
cation field for the threshold value
Rotary knob "Attack" with input/indica-
tion field for the attack time
Rotary knob "Hold" with input/indication
field for the hold time
Rotary knob "Release" with input/indica-
tion field for the release time
Rotary knob "Ratio" with input/indication
field for the compression ratio
Rotary knob "Makeup Gain" with input/
indication field for level loss compensa-
tion
21
Werbung
Inhaltsverzeichnis
