RTI NEO ONE Bedienungsanleitung Seite 15

Manual: RTI NEO ONE
After selecting the IP address, you will enter the menu for setting the IP network mode
of the ShowNET. You can choose between the following three modes by turning the data
wheel left / right:
a) Static IP
b) DHCP
c) Auto IP
More information and troubleshooting on www.showeditor.com and
www.laserworld.com/shownet
Press the data wheel to confirm your selection and to enter the next menu.
In the last menu before returning to the starting display you can enable / disable the
scanfail safety by turning the data wheel left / right:
a) Scanfail safety OFF
b) Scanfail safety ON (display turns red)
7. Turn off
To turn off the device, disconnect the power cable from the PSU.
Important: Before transporting the laser device, remove both the key and the Interlock
connector from the RTI NEO ONE PSU to prevent damage.
page 15 / 48