Assembly Steps - Silvercrest STW 32 - 60 A1 Montageanleitung

Assembly steps

GB
IE
Step 1: Attaching the mounting rails
A B C
Step 2: Attaching the wall bracket to the wall
6
♦ Check whether the supplied screws (
on the back of your TV set. If this is not the case, please use other suitable
screws and washers.
♦ Attach the mounting rail so that the screw heads for adjusting the tilt angle
face outwards and the hooks are facing downward. Screw the mounting rail
tight using the suitable screws (
run parallel and are aligned at the same height.
♦ For TV sets with a fl at back, no spacers
mounting rails with the appropriate screws and washers directly onto the
rear panel of the device.
♦ For TV sets with a curved rear panel, it may be necessary to use the supplied
spacers between the TV set and the mounting rail.
D
E
♦ Start by selecting a suitable mounting height. The ideal height for a TV set is
parallel to the eye-level of a seated person.
♦ Hold the wall bracket up to the to the desired position on the wall to use
as a template and align it with the aid of a spirit level. Mark the 4 holes
with a pencil.
, or ) fi t in the prepared holes
A B C
, or ) and washers
A B C
are usually required. Fasten the
D
A B C
E
so that they
E
D
STW 32 - 60" A1