Adjustments - Pattfield PA-1200BH Originalbetriebsanleitung

FIT CHISEL OR DRILL
1 Slide back the locking sleeve 2.
Caution! Make sure the tool is
switched off and unplugged and
wear protective gloves.
3 Make sure that the chisel or drill is fully
inserted.
HAMMER FUNCTION
1 Set the top hammer-drill / hammer
switch 1 to hammer .
Caution! Only set operation modes
while the aplliance is switched off.
HAMMER-DRILL FUNCTION
1 Set the top hammer-drill / hammer
switch 1 to hammer-drill
Caution! Only set operation modes
while the aplliance is switched off.
DRILL FUNCTION
1 Set the top hammer-drill / hammer
switch 1 to hammer-drill
Caution! Only set operation modes
while the aplliance is switched off.
2 Fit the SDS-plus chisel or drill into the
chuck 3.
4 Relase the locking
if the chisel or drill is securely fixed.
To remove the chisel or drill, slide back
the locking sleeve
chisel or drill.
2 Set the rear hammer-drill / drill
to hammer-drill
2 Set the rear hammer-drill / drill
. to hammer-drill
2 Set the rear hammer-drill / drill
. to drill .
sleeve 2 and check
2
and pull out the
switch 6
.
switch 6
.
switch 6
EN 87