Troubleshooting - Inventum IKK1785S Gebrauchsanleitung

Warning Never remove ice with sharp objects, defrosting sprays, a hair dryer, a heater or something similar. This could lead
to unsafe situations and cause irreparable damage to the appliance.
REPLACING THE LED LAMP
This appliance has been provided with a LED lamp. This lamp lasts for a longer period of time. When the LED lamp in the
appliance is broken, you are not able to replace it yourself. Contact the Inventum service department.
TIPS
• A high ambient temperature will have a negative effect on the energy consumption. Direct sunlight and other heat
sources near the larder also have a negative effect.
• Keep ventilation holes free. Covered and dirty holes cause a high energy consumption. Ensure sufficient space around
the larder, so that a proper ventilation and air flow around the larder is possible.
• Do not open the door of the larder more often than necessary and leave the door open as short as possible.
• The distance between the shelves and the rear wall ensures a free air circulation. Do not place food against the rear wall.
• Set the thermostat to a lower setting if circumstances allow.
• Allow cooked food that you want to store in the larder to cool down to room temperature before placing it in the larder.
• Frost or ice will increase power consumption. Therefore, these should be removed regularly once they are 3 to 5 mm
thick.
• A door rubber that does not close properly could increase the power consumption. Therefore, have it replaced by a
skilled person in time.
• The condenser at the rear of the larder must always be kept clean and free from dust.
• If the instructions are not observed, this could lead to a higher power consumption.
• If you do not use the appliance for a longer period of time (e.g. during holidays), switch the thermostat to setting ●.
Defrost and clean the larder. Leave the doors slightly open to prevent moulds and smells.
7

troubleshooting

If your larder does not work properly, this can be caused by a minor problem. First check the following items before
contacting an electrician. This will save you time and money.
Problem
Appliance does not do anything;
led does not light up
Temperature in the larder is too
high or too low
There is water running out of the
larder
Appliance makes noise
Lighting does not burn
The ALARM indicator light lights
up.
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
18
• English
Cause
- Plug not in socket
- Power interruption
Incorrect temperature setting
Ventilation holes are blocked
Defrost water drain is blocked
Is the appliance properly installed?
Does the rear of the larder make
contact with something?
Lamp is defective
The plug is inserted in the socket
for the first time or there has been
a power interruption of at least one
hour.
A component is defective or there is
a breakdown in the cooling process.
Solution
- Insert the plug in the socket.
- Check the fuse box.
Set the correct temperature.
Clean the ventilation holes.
Open the defrost water drain by pricking
through it with a wooden skewer.
Check the installation - is the larder level?
Check this and move the larder forward
Contact customer service.
Check that the door of the appliance is
properly closed and check that the appli-
ance has been on for more than one hour.
If this is not the case, contact customer
service.
Contact customer service.