Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Installation Instructions
Make sure the power is removed before the installation.
4.1 Power Supply Connections
Camera can be operated with VDC and the regulated power supply of VDC / 0.5A min. is recommended.
Camera is protected from the damage by the reverse connection of polarity.
4.2 Installation Procedure
Make sure the power is removed before the installation.
) Locate camera at the installation position and install a screw through (8) Bracket mount hole.
) Adjust the pan of the camera and install one or two screws through (9) Pan fixing screw hole on the wall.
3) Adjust the tilt of the camera and tighten two (6) Screws for fixing Bracket.
4) Route the power/video cable to the connecting place.
ATTENTION: Care should be taken the cable is NOT to be damaged, kinked or exposed in the hazardous area.
5. SETUP Menu
Setup menu can be controlled by the OSD switches at (4) Rear cover.
In the menu description,
• Short (d) ENTER Press the button straight down less than 0.5 sec.
• Long (d) ENTER: Press the button straight down longer than sec.
• (a) UP, (b) LEFT, (c) DOWN, (e) RIGHT: Push the button to the indicated directions less than 0.5 sec.
5.1 In the Menu
Use (a) UP, (c) DOWN buttons to move menu, (b) LEFT, (e) RIGHT buttons to change the settings
and press Short (d) ENTER to select or Long (d) ENTER for entering/exiting MENU.
3
Werbung
Inhaltsverzeichnis
