General Safety Instructions; Special Safety Instructions; Unpacking; Instruction Manual - Clatronic T-VL 2976 Bedienungsanleitung

General Safety Instructions

Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
• The appliance is designed exclusively for private use and for
the envisaged purpose. This appliance is not fi t for commer-
cial use. Do not use it outdoors. Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull the plug
itself, not the lead) if the appliance is not being used and
remove the attached accessories.
• Do not operate the machine without supervision. If you
leave the room you should always turn the device off.
Remove the plug from the socket.
• Check the appliance and the cable for damage on a regular
basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualifi ed
person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instruc-
tions".
Children and Frail Individuals
• In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
WARNING!
Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
• In order to protect children or frail individuals from the haz-
ards of electrical equipment, please ensure that this device
is only used under supervision. This device is not a toy. Do
not allow small children to play with it.
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is
essential to comply with these instructions in order to avoid ac-
cidents and prevent damage to the machine:
WARNING !
This warns you of dangers to your health and indicates
possible injury risks.
CAUTION:
This refers to possible hazards to the machine or other
objects.
NOTE: This highlights tips and information.
05-TVL 2976 Neu.indd 19 05-TVL 2976 Neu.indd 19

Special safety instructions

• Never stick fi ngers or other objects through the protection
grid!
• Watch out for long hair! It can be caught in the fan owing to
the air turbulence!
• Use the appliance only with the protection grids on!
• The appliance must be assembled completely before use!
• Select a stable base to avoid the tipping of the fan during
use!
• Do not use the fan on windowsills.
• Do not use the fan in premises where gasoline, paints or
infl ammable liquids are used or stored.
• The fan must be used only in the envisaged position (stand-
ing).
• Do not place the device immediately next to stoves or other
sources of heat.
Assembly instructions

Unpacking

• Remove the single parts from the box. Do not throw the
packing away, but keep it for the whole life of the warranty.
• Insert the plug in the socket only once you have carefully
read instructions and assembled the fan completely.
Assembly of Component Parts
(see illustrations ABB. 1 and ABB.
1. Lay the fan level on fl oor.
2. Mount the front and rear stand plates so that the power
cable is inserted through the resulting slot (C) and the plug
is located on the lower face of the stand plate.
3. Attach the fan to the bottom plate by slightly lifting the fan
and fi tting in the bottom plate. Tighten the two fastening
screws (A) to attach the bottom plate.
4. Thread the cable into the recess provided (B).
5. Place the fan on a suitable and stable surface.
Putting into function
1. Connect the appliance to a properly installed 230V, 50Hz
socket with earthing protection.
2. 3 speeds can be selected with the press buttons 0 – 3.
0 = off, 1 = low, 2 = medium, 3 = high.
3. By pressing the oscillation selector the constant oscillatory
movement of the fan is activated or deactivated.
4. Switch on the fan:
• Normal mode:
a) Turn the switch knob counterclockwise to the ON
position.
b) Select a speed between 1 and 3.
• Timer mode:
a) Turn the switch knob clockwise. Functioning periods
of up to 120 minutes can be selected.
b) Select a speed between 1 and 3.
At the end of the set time the fan shuts off automati-
cally.
2)
19
07.10.2008 15:51:15 Uhr 07.10.2008 15:51:15 Uhr