Dorr SnapShot Limited 5.0S Bedienungsanleitung Seite 17

1. Press the arrow buttons (7)
2. Press the arrow buttons (7)
3. Press the arrow buttons (7)
4. To save your settings press the the "OK" button (8). To leave setup without saving, press the "MENU" button (6).
07 | CAMERA SETTINGS CAM
CAMERA/VIDEO MODE
Select between single photo or video shooting.
1. Press the arrow button (7)
2. Press the arrow buttons (7)
3. Save with "OK" button (8).
Video quality 640 x 480 Pixels
Video length 10 seconds (not changeable)
PICTURE RESOLUTION
Select between 3 MP or 5 MP picture resolution.
1. Press the arrow button (7)
2. Press the arrow buttons (7)
3. Save with "OK" button (8).
NUMBER OF SHOTS
Select number of shots per motion.
1. Press the arrow button (7)
2. Press the arrow buttons (7)
3. Save with "OK" button (8).
08 | MOTION SENSOR SETTINGS
SENSITIVITY
Choose the sensitivity of the motion sensor or turn the sensor o .
1. Press the arrow button (7)
2. Press the arrow button (7)
3. Save with "OK" button (8).
TRIGGER INTERVAL
Select time (5 sec to 60 min) when PIR sensor is deactivated after a shot.
1. Press the arrow button (7)
2. Press the arrow buttons (7)
3. Save with "OK" button (8).
TIME LAPSE
Set the interval of continuous photo shooting. Camera shoots photos during this time setting (5 sec to 8 h) regardless of the
motion sensor. If selected "OFF" the camera triggers upon motion. This setting is useful e.g. for observing a larger area in a
certain period.
or to switch between the registers (CAM, PIR, SYS).
or to select the menu point. The selected menu point is marked white.
or to change the menu point.
to select "Camera Mode".
or select "Photo" or "Video".
to select Photo Size "5MP".
or to select "3MP"
to select "Photo burst".
to select "1 Photo" "2 Photos" or "3 Photos".
or
PIR
to select "Sensitivity".
oder to select "Normal", "High", "Low" or "Off".
to select "Trigger Interval".
or to select time.
17