Bluetooth Remote; Operation Remote Control - Lupine Betty R Bedienungsanleitung

3

Bluetooth Remote

Connecting the transmitter to the light:
By default, your lamp has already been connected to the transmitter.

For establishing a connection, the receiving mode in the lamp has to be activated.
Keep the lamp's button depressed until fi ve green LEDs light up and let the
button go. The receiving mode is now active for 30 seconds. During this time, press the
remote control's button until the remote does light up green. release the button

Several lamps and one transmitter:
It is possible to connect up to fi ve lampheads to a single remote switch.
Several transmitters and one lamp:
Up to 4 transmitters may be connected to one lamp. The transmitter-specifi c codes are
stored in the lamp according to a "fi rst in fi rst out" principle. If you want to use only one
transmitter again to control your lamp, it might be necessary to connect this transmitter
up to 4 times with the lamp until all other codes in the list will have been overwritten.
3 8 Betty R