Lupine Betty R Bedienungsanleitung Seite 39

3
Enable/Disable the remotes permanent LED light:
Keep the remote button depressed: The LEDs must turn green then blue
again. release the button

Low battery warning from lamphead:
The remote mirrors the lamphead's low battery warning.
A fully charged or partly discharged battery will be shown by a red LED light.
Details see page 36.
There will be no warning if the remotes button cell itself is empty.
Low button cell:
With decreasing voltage, the remotes LEDs will also become weaker, to
the point the remote does not work anymore. Also cold temperature does
reduce the battery voltage. If the button cell is empty, it's represented by a
red light.
Transmitter battery change:
For changing the battery, loosen all 4 screws at the bottom
of the transmitter using a T5 torx screw driver.
Insert the new CR 2032 button cell as shown and close
the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
T5 torx screw driver: (Art.No. 137)
Betty R 3 9