Turning Power On/Off; Turning On The Main Power - Sharp PN-V600 Installationsanleitung

Caution
• Turn on the monitor first before turning on the PC or
playback device.

Turning on the main power

Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
• For a complete electrical disconnection, pull out the main
plug.

Turning power on/off

Press the POWER button on the remote control unit or the
monitor itself to turn the power ON/OFF.
When the main power switch is off, the monitor cannot be
turned on using the POWER button on the remote control unit.
Power LED Power button
Status of a power LED
Lit green
Lit orange
Flashing green
Turning Power On/Off
Main power switch
Status of the monitor
Power on
Power off (Standby mode)
Input signal waiting mode
nOperation mode
When the monitor is turned on for the first time after being
shipped from the factory, the operation mode setting screen
will be displayed. Set it to MODE1 or MODE2.
MODE1 ....OFF IF NO OPERATION is set to ON, and
STANDBY MODE is set to LOW POWER. (These
settings can not be changed.)
If there is no operation for 4 hours or more, the
monitor automatically enters standby mode. Power
consumption in standby mode is also minimized.
MODE2 ....Will perform standard operation.
OFF IF NO OPERATION is set to OFF, and
STANDBY MODE is set to STANDARD. These
settings can be changed.
Even after being set, changes can be made using
OPERATION MODE, located in the menu of the monitor. (See
Operation manual.)
nDate/time setting
• If the time has yet to be set when the monitor is first turned on,
the date/time setting screen appears. Set the date and time.
DATE/TIME SETTING
/ /
SET 01 /
CANCEL
1. Press , ,
time, and press or
values.
2. Press or to select SET and then press
• Be sure to set the date and time.
• The date/time setting screen will close automatically if no
operation is performed for about 15 seconds. The date
and time can be set using DATE/TIME SETTING from the
OPTION menu when the date/time setting screen disappears.
TIPS
• Set the date in "Day/Month/Year" order.
• Set the time on a 24-hour basis.
The clock is maintained by the internal battery.
•
If you already set the time but the date/time setting
•
screen appears when the power is turned on, the
internal battery may be exhausted. Please contact
your local Sharp servicing dealer or service center for
assistance with battery replacement.
• Estimated service life of the internal battery: About 5
years (depending on monitor operation)
The initial battery was inserted at the factory when the
•
monitor was shipped, so it may run out of power before
its expected operation life.
: :
01 / 20 11 00 : 00
OK···[MENU]
or to select the date and
to change the numerical
MENU
.
7
E