Specifications - Roadstar TRA-1967 Bedienungsanleitung

WARNINGS
230v~ This unit operates on 230V ~ 50Hz. If the unit is not used for a long period
of time, remove the plug from the AC mains.
This unit must not be exposed to moisture or rain.
Ensure all connections are properly made before operating the unit.
This unit should be positioned so that it is properly ventilated. Avoid
placing it, for example, close to curtains, on the carpet or in a built-in
installation such as a bookcase.
Do not expose this unit to direct sunlight or heat radiating sources.
Make sure all batteries are inserted according to the proper
- +
polarity. Do not mix old batteries with new ones.
If the unit is not used for a long period of time (more than 1 month),
- +
remove all batteries from their compartment to avoid possible leaking.
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
This marking shown on the product or its literature, indicates that it should not
be disposed with other household wastes at the end of its working life. To prevent
possible harm to the environment or human health from uncontrolled waste
disposal, please separate this from other types of wastes and recycle it
responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this
product, or their local government office, for details of where and how they
can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions
of the purchase contract. This product should not be mixed with other commercial
wastes for disposal.

SPECIFICATIONS

Power Supply
AC: 230V ~ 50Hz
Batteries: 4 x UM-2 (radio operation)
Radio Frequency Coverage
FM: 87.5 - 108 MHz
MW: 530 - 1600 kHz
General
Headphones: 3.5mm stereo jack plug, 8-32Ω
Note: Specifications and the design are subject to possible modifications without notice due to
improvement. Rating plate is located at the bottom enclosure of the apparatus
1
English
TRA-1967 2-BANDS Portable Radio.
LOCATION OF CONTROLS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Battery Compartment
11. DC 6V Input
POWER SUPPLY
Battery Operation
•
•
•
•
AC Power Operation
•
Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
AUX IN FUNCTION
1.
2.
RADIO OPERATION
1.
2.
3.
4.
5.
6.
HEADPHONES
Headphones should have a 3.5 mm diameter stereo plug and an impedance of 8-32 ohms,
and should be connected to the HEADPHONES Socket (4). When headphones are
connected, the speaker iss automatically disconnected.
.
2 English
ON/OFF/VOLUME Control
TUNING Control
Handle
HEADPHONE Jack
RADIO Dial Scale
BAND Selectors (MW/FM)
Mute function
AUX-IN selector
AUX-IN jack
Open the Battery Compartment (10) at the back of the unit.
Insert first 4 x UM-2 batteries following the polarity diagram shown inside the battery
compartment.
Batteries should be removed from the compartment if the unit is not to be used for
some time.
Flat batteries should be removed from the unit to avoid leakage.
Connect the AC Power Adapter to your AC household mains outlet and switch on the
mains supply. Make sure the voltage is compatible.
Press the Aux button (8).
You can put the other audio products through the Aux in jack (9).
Turn the VOLUME/OFF knob (1) until you hear a click.
Adjust the volume by turning the VOLUME control.
Extend the telescopic antenna for FM Band. To optimize MW reception turn horizontally
the radio until reaching the best reception position.
Select the desired radio Band (FM/MW) with the Band selector (6).
Tune to the desired station with the Tuning knob (2).
To switch off the radio turn the volume knob counterclock-wise until a click is heard.