Technical Data; Installation - Kalorik TKG WCL 4 Gebrauchsanleitung

Fax +32 2 359 95 50


TECHNICAL DATA

Volume
Capacity
Adjustable temperature
Without CFC

INSTALLATION

Free-standing or built-in
The appliance can be installed either free-standing or built-in.
Place the wine cooler away from direct sunlight and sources of heat (e.g. stove, heater...) as
direct sunlight may affect the acrylic coating and heat sources may increase the consumption
of electricity. An ambient temperature below 16°C or above 25°C will hinder the performance
of this appliance. Do not install the appliance in a garage or outside. Avoid moist areas.
Placing the self-standing appliance
Place the appliance firmly on a solid base. Some appliances have adjustable feet on the front
side; use them to level the appliance.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don‟t change the page numbering. Keep the
language integrity.
155 litres
44 bottles of 750 ml
4°C – 16°C
If you want to build it in, respect the
dimensions of the illustration. The depth
must be 610 mm. If you respect these
dimensions, you will be able to open the
door and to place or remove the shelves.
If the appliance is installed between
cabinets, you may need to put a 13 mm
wide filler strip or a side panel on the
hinge side to prevent the doors of the
cabinets from slamming into the wine
cooler.
The door of the wine cooler should
protrude at least 25 mm compared to the
surrounding cabinets.
13
Assembly page 13/64
TKG WCL 4 - 071117