Set Up; Installation; Connections - Omnitronic DMP-202 Bedienungsanleitung

19 Audio output LINE OUT B
Stereo output (unbalanced RCA) of player mechanism B
for connecting an amplifier, a mixer or other units with line
level inputs.
20 Audio output LINE OUT A
Stereo output (unbalanced RCA) of player mechanism A
for connecting an amplifier, a mixer or other units with line
level inputs.

5. SET UP

5.1 Installation

Install the unit on a plane surface or in your rack. For 19" (483 mm) rack installation 1 unit is required. Screw
on the two supplied mounting brackets at the left and right sides of the housing. When mounting the unit into
the rack, please make sure that there is enough space around the device so that the heated air can be
passed on. Steady overheating will damage your device. You can fix the unit with four screws M6 in the rack.

5.2 Connections

Prior to making or changing any connections, switch off the DMP-202 and the units to be connected.
1
Connect subsequent units with line level inputs (e.g. amplifier or mixer) to the unbalanced RCA outputs
LINE OUT A and B. Make sure that the right/left occupation is the same at the units.
2
Finally, use the supplied power cable to connect the unit to the mains.
21 Power input
Plug in the supplied power cable here.
19/24 00071450.DOC, Version 1.0