3 3 M M o o u u n n t t i i n n g g
( ( D D e e - - ) ) M M o o u u n n t t i i n n g g o o n n t t h h e e t t o o p p - - h h a a t t r r a a i i l l s s
Mounting
Snap the WaveLine Medienconverter vertically on a
horizontal DIN rail.
C C a a u u t t i i o o n n
- The WaveLine Mediaconverter is designed for top hat rail mounting according to
standard EN50022. Using a different top hat rail can result in improper mounting.
Use a top hat rail according to standard EN 50022. Pay attention to the mounting
instructions of the manufacturer.
- It is not allowed to mount or demount the WaveLine Medienconverter during ope-
ration.
- There must be 2" (ca. 5 cm) free space on both sides (top and bottom) for venti-
lation to the next device. The WaveLine Mediaconverter can be mounted side by
side with other WAVE-Line devices.
- To ensure proper ventilation through the device the unit shall be mounted on a
DIN-Rail which is oriented horizontal on the vertical rear wall of the control cabinet.
Demounting
For demounting use a flat-bladed screwdriver,
open the latch at either the top or bottom of
the switch.
20