Installation - BOMANN DU 770 G Bedienungsanleitung

Installation

Installation
Installation Installation
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 60 The The The distance must be between 60 distance must be between 60 – – – – 80 distance must be between 60
appliances, the distance must be at least 65 cm. If appliances, the distance must be at least 65 cm. appliances, the distance must be at least 65 cm. appliances, the distance must be at least 65 cm.
the installation instructions for the gas cooker specify
a greater distance, this distance must be taken into
consideration.
Selecting the fume outlet Selecting the fume outlet
Selecting the fume outlet Selecting the fume outlet
You can operate the cooker hood in two modes:
Extraction mode Extraction mode
Extraction mode Extraction mode
WARNING: WARNING: WARNING: WARNING:
• The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
• When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odours to the outside.
The extracted air is normally vented verti-
cally. The extracted air can vented
through the wall units and the loft floor to
the roof ridge.
If there is a conduit under the wall units,
the extraction duct can be routed so that
the extracted air can be vented horizon-
tally through the wall.
Recirculation mode Recirculation mode
Recirculation mode Recirculation mode
If you do not have a direct extraction vent to the out-
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, an activated carbon filter as described under
"Installing the activated carbon filter for recirculation
mode", must be used.
Activated carbon filter are not supplied. You can or-
der the carbon filter from your dealer or in our online
accessories shop,
the reference number found under "Technical Data".
80 cm. For gas 80 80 cm. For gas cm. For gas cm. For gas
Assembly Assembly Assembly Assembly
• When assembling or inserting the extraction filter
• Failure to use the mounting fixtures may lead to a
• Before mounting, check that the wall has sufficient
• When drilling the holes in the wall always make
• Make sure that the ventilation slots are clear of
• When installing, ask another person to assist.
• Wear protective gloves to prevent injuries from
• Determine the position of the cooker hood central-
• Align the drilling template horizontally and mark
• Drill mounting holes 4 x Ø8 mm and insert the
16
www.bomann.de www.bomann.de. To order, use
www.bomann.de www.bomann.de
WARNING: WARNING:
WARNING: WARNING:
as well as the carbon filter, the appliance must not
be connected to the mains.
risk of electric shock risk of electric shock. risk of electric shock risk of electric shock
CAUTION CAUTION: : : : CAUTION CAUTION
load capacity to bear the cooker hood.
sure that no existing electrical cables or other ob-
jects are damaged.
obstacles and are not covered.
NOTE: : : : Recomm NOTE Recommendations for preparation work endations for preparation work
NOTE NOTE Recomm Recomm endations for preparation work endations for preparation work
any sharp edges.
ly above the hob in conformance with the speci-
fied safety distances.
the necessary holes for the wall mounting. Check
them with a spirit level.
dowel pins.