Lightmaxx Platinum Line LED Strobe X9 Bedienungsanleitung Seite 3

Manual Mode:
To run the Lightning cracker Strobe in Manual mode, set all dip switches to the "OFF" position.
In manual mode the unit will function as a normal strobe light, Rate (speed) and intensity (brightness)
are set directly on the unit. Note that these settings are made by using the controls on the rear of the
unit. Once the settings are made they can only be changed by physically adjusting the controls on the
unit. Be aware of this if you plan on installing your strobe in a permanent installation.
Flash speed is controlled via the SPEED control
Flash dimming is controlled via the DIMMER control
Sound active Mode:
To run the Lightning cracker Strobe in Sound active mode, set dip switch 9 to the "ON" position.
The Dimming will still be controlled by the DIMMER control on the back of the unit. Note that these
settings are made using the controls on the rear of the unit. Once the settings are made they can only
be changed by physically adjusting the controls on the unit. Be aware of this if you plan on installing your
strobe in a permanent installation.
Flash Dimming is controlled via the DIMMER control
Flash Speed is controlled by the Music
DMX Mode:
To run the Firecracker Strobe into DMX mode, set dip switch 10 to the "ON" position. You can now set
the required DMX address using dip switches 1 to 9. The start address for this fixture is 1. Please refer
to the chart below for DMX functions.
Channel
1
2
Technische Daten:
Voltage
DMX – Channels
Power Consumption
Light Source
Dimensions
Weight
Value
0 – 255
0 – 255
www.musicstore.com
Function
Flash Speed
Flash Dimmer
240V – 50Hz
2 (Speed / Dimmer)
40 Watt
9 x 3,5 Watt LED Stripes
335 x 210 x 110 mm
2,0 Kg